|
|
|
|
 |
Transducers, Energy Meters, Power Analyzers,
Current and Voltage Transformers, Serial Communication modules.
Compact Transducers for AC, DC and frequency measurement.
Power Transducers, power analyzers and energy meters for network
management of electrical lines in industrial and residential
applications. DIN-rail or panel mounting types.
|
| Sense |
Switch |
Control |
Safety |
| Temperature Sensors |
Solid State Relay |
Energy Management |
Safety Module |
| Proximity Sensors |
Motor Controller |
Temp. Controller / Scanner |
Safety light Curtain |
| Ultrasonic Sensors |
Power Supply |
Timer / Monitoring Relay |
Safety Switches |
| Level Sensors |
PCB Relay |
Counter |
Thyristor fuses |
| Humidity Sensors |
Converters |
Heater Control |
Safety Magnetic Switches |
|
| Monitoring Solutions
for Water and Pumps Applications |
|
| Monitoring Solutions
for Energy Generation Applications |
|
|
|
|
Your issue
What happens if my pump runs dry? What if the phases sequence
is not correct or one phase fails.
|
|
|
|
Your issue
With an increased use of generators in a lot of application
it's absolutely necessary that the mains out of the generator
is of high quality to avoid damages to the load connected.
|
|
| Monitoring Solutions
Applications for Material Handling |
|
|
|
|
Your issue
All the industrial applications where sophisticated mechanical
machines are used to manufacture, pack-age, mix... they need
a high quality mains. A faulty system can cause poor product
quality.
|
|
|
|
Your issue
Industrial plants using advanced technological machines to
optimize the productivity level and the product quality often
need to monitor the quality of the mains.
|
|
| Monitoring Solutions
Applications for Lift |
|
|
|
|
Your issue
For Lifts the direction of the motion must be 100% correct.
Phase sequence relays are a fast, reliable and easy to maintain
solution. In case of overload the motor temperature can damage
and eventually break the motor itself.
|
|
|
|
Your issue
Correct direction means higher efficeincy of the compressor
(in some cases incorrect rotation means immediate break down).You
never know what's going to happen after the compressor has
been set up. Furthermore, starting more than one compressor
of the same time can cause a high inrush current with several
problems like EMC noise or low mains voltage.
|
|
|
• 15 Amp models
• Economical open board design and ideal for high volume
applications
• Settings for ramps and initial torque |
|
|
|
• 3,12 & 25Amp models
• Soft starting & stopping
• Single Ø available
• Transient over voltage protection built-in
|
|
|
|
• 25, 36 & 45 amp models
• Soft starting & supporting
• Vibration-free starting
• Integrated heat sink
• Motor PTC input connection
• Over- temperature protection
|
|
|
|
• 72, 90 Amp models
• Soft start/stop of all type of three Ø induction
motors
• 10 per-programmed start/stop profiles
• Phase loss protection at starting
• Fault status indication
|
|
